| MOBILE | 
		
			| Mobile module | 4G (LTE) – Cat 4 up to 150 Mbps, 3G – Up to 42 Mbps, 2G – Up to 236.8 kbps | 
		
			| SIM switch | 2 SIM cards, auto-switch cases: weak signal, data limit, SMS limit, roaming, no network, network denied, data connection fail, SIM idle protection | 
		
			| Status | Signal strength (RSSI), SINR, RSRP, RSRQ, EC/IO, RSCP, Bytes sent/received, connected band, IMSI, ICCID | 
		
			| SMS | SMS status, SMS configuration, send/read SMS via HTTP POST/GET, EMAIL to SMS, SMS to EMAIL, SMS to HTTP, SMS to SMS, scheduled SMS, SMS autoreply, SMPP | 
		
			| USSD | Supports sending and reading Unstructured Supplementary Service Data messages | 
		
			| Black/White list | Operator black/white list | 
		
			| Multiple PDN | Possibility to use different PDNs for multiple network access and services | 
		
			| Band management | Band lock, Used band status display | 
		
			| APN | Auto APN | 
		
			| Bridge | Direct connection (bridge) between mobile ISP and device on LAN | 
		
			| Passthrough | Router assigns its mobile WAN IP address to another device on LAN | 
		
			| WIRELESS | 
		
			| Wireless mode | IEEE 802.11b/g/n, Access Point (AP), Station (STA) | 
		
			| WiFi security | WPA2-Enterprise - PEAP, WPA2-PSK, WEP, WPA-EAP, WPA-PSK; AES-CCMP, TKIP, Auto Cipher modes, client separation | 
		
			| SSID/ESSID | SSID stealth mode and access control based on MAC address | 
		
			| WiFi users | Up to 100 simultaneous connections | 
		
			| Wireless Hotspot | Captive portal (Hotspot), internal/external Radius server, built in customizable landing page | 
		
			| ETHERNET | 
		
			| WAN | 1 x WAN port  10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX | 
		
			| LAN | 3 x LAN ports, 10/100 Mbps, compliance IEEE 802.3, IEEE 802.3u standards, supports auto MDI/MDIX | 
		
			| NETWORK | 
		
			| Routing | Static routing, Dynamic routing (BGP, OSPF v2, RIP v1/v2, RIPng, OSPF6) | 
		
			| Network protocols | TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSL v3, TLS, ARP, VRRP, PPP, PPPoE, UPnP, SSH, DHCP, Telnet client, SNMP, MQTT, Wake On Lan (WOL) | 
		
			| VoIP passthrough support | H.323 and SIP-alg protocol NAT helpers, allowing proper routing of VoIP packets | 
		
			| Connection monitoring | Ping Reboot, Wget Reboot, Periodic Reboot, LCP and ICMP for link inspection | 
		
			| Firewall | Port forward, traffic rules, custom rules | 
		
			| DHCP | Static and dynamic IP allocation, DHCP Relay, Relayd | 
		
			| QoS / Smart Queue Management (SQM) | Traffic priority queuing by source/destination, service, protocol or port, traffic priority queuing by source/destination, service, protocol or port, WMM, 802.11e | 
		
			| DDNS | Supported >25 service providers, others can be configured manually | 
		
			| Network backup | WiFi WAN, Mobile, VRRP, Wired options, each of which can be used as an automatic Failover | 
		
			| Load balancing | Balance your internet traffic over multiple WAN connections | 
		
			| Hotspot | Internal/external Radius server, captive portal, built in customizable landing page | 
		
			| SSHFS | Possibility to mount remote file system via SSH protocol (not available in standard FW) | 
		
			| SECURITY | 
		
			| Authentication | Pre-shared key, digital certificates, X.509 certificates | 
		
			| Firewall | Pre-configured firewall rules can be enabled via WebUI, unlimited firewall configuration via CLI; DMZ; NAT; NAT-T | 
		
			| Attack prevention | DDOS prevention (SYN flood protection, SSH attack prevention, HTTP/HTTPS attack prevention), port scan prevention (SYN-FIN, SYN-RST, X-mas, NULL flags, FIN scan attacks) | 
		
			| VLAN | Port and tag based VLAN separation | 
		
			| Mobile quota control | Set up custom data limits for the SIM card | 
		
			| WEB filter | Blacklist for blocking out unwanted websites, whitelist for specifying allowed sites only | 
		
			| Access control | Flexible access control of TCP, UDP, ICMP packets, MAC address filter | 
		
			| VPN | 
		
			| OpenVPN | Multiple clients and server can be running simultaneously, 12 encryption methods | 
		
			| OpenVPN Encryption | DES-CBC, RC2-CBC, DES-EDE-CBC, DES-EDE3-CBC, DESX-CBC, BF-CBC, RC2-40-CBC, CAST5-CBC, RC2-64-CBC, AES-128-CBC, AES-192-CBC, AES-256-CBC | 
		
			| IPsec | IKEv1, IKEv2, supports up to 4 x VPN IPsec tunnels (instances), with 5 encryption methods (DES, 3DES, AES128, AES192, AES256) | 
		
			| GRE | GRE tunnel | 
		
			| PPTP, L2TP | Client/Server services can run simultaneously | 
		
			| Stunnel | Proxy designed to add TLS encryption functionality to existing clients and servers without any changes in the programs' code | 
		
			| SSTP | SSTP client instance support | 
		
			| ZeroTier | ZeroTier VPN | 
		
			| WireGuard | WireGuard VPN client and server support | 
		
			| MODBUS TCP SLAVE | 
		
			| ID filtering | Respond to one ID in range [1;255] or any | 
		
			| Allow Remote Access | Allow access through WAN | 
		
			| Custom registers | MODBUS TCP custom register block requests, which read/write to a file inside the router, and can be used to extend MODBUS TCP Slave functionality | 
		
			| MODBUS TCP MASTER | 
		
			| Supported functions | 01, 02, 03, 04, 05, 06, 15, 16 | 
		
			| Supported data formats | 8 bit: INT, UINT; 16 bit: INT, UINT (MSB or LSB first); 32 bit: float, INT, UINT (ABCD (big-endian), DCBA (little-endian), CDAB, BADC) | 
		
			| MODBUS DATA TO SERVER | 
		
			| Protocol | HTTP(S), MQTT, Azure MQTT | 
		
			| MQTT GATEWAY | 
		
			| MQTT gateway | Allows sending commands and receiving data from MODBUS Master through MQTT broker | 
		
			| DNP3 | 
		
			| Supported modes | TCP Master, DNP3 Outstation | 
		
			| MONITORING & MANAGEMENT | 
		
			| WEB UI | HTTP/HTTPS, status, configuration, FW update, CLI ,troubleshoot, event log, system log, kernel log | 
		
			| FOTA | Firmware update from sever, automatic notification | 
		
			| SSH | SSH (v1, v2) | 
		
			| SMS | SMS status, SMS configuration, send/read SMS via HTTP POST/GET | 
		
			| Call | Reboot, Status, WiFi on/off, Mobile data on/off, Output on/off | 
		
			| TR-069 | OpenACS, EasyCwmp, ACSLite, tGem, LibreACS, GenieACS, FreeACS, LibCWMP, Friendly tech, AVSystem | 
		
			| MQTT | MQTT Broker, MQTT publisher | 
		
			| SNMP | SNMP (v1, v2, v3), SNMP trap | 
		
			| JSON-RPC | Management API over HTTP/HTTPS | 
		
			| MODBUS | MODBUS TCP status/control | 
		
			| RMS | Teltonika Remote Management System (RMS) | 
		
			| IoT PLATFORMS | 
		
			| Cloud of Things | Allows monitoring of: Device data, Mobile data, Network info, Availability | 
		
			| ThingWorx | Allows monitoring of: WAN Type, WAN IP Mobile Operator Name, Mobile Signal Strength, Mobile Network Type | 
		
			| Cumulocity | Allows monitoring of: Device Model, Revision and Serial Number, Mobile Cell ID, ICCID, IMEI, Connection Type, Operator, Signal Strength, WAN Type and IP | 
		
			| Azure IoT Hub | Can send device IP, Number of bytes send/received/ 3G connection state, Network link state, IMEI, ICCID, Model, Manufacturer, Serial, Revision, IMSI, Sim State, PIN state, GSM signal, WCDMA RSCP WCDMA EC/IO, LTE RSRP, LTE SINR, LTE RSRQ, CELL ID, Operator, Operator number, Connection type, Temperature, PIN count to Azure IoT Hub server | 
		
			| SYSTEM CHARACTERISTICS | 
		
			| CPU | Mediatek MIPS 24Kc 580 MHz | 
		
			| RAM | 128 MB, DDR2 | 
		
			| FLASH storage | 16 MB, SPI Flash | 
		
			| FIRMWARE / CONFIGURATION | 
		
			| WEB UI | Update FW from file, check FW on server, configuration profiles, configuration backup, restore point | 
		
			| FOTA | Update FW/configuration from server | 
		
			| RMS | Update FW/configuration for multiple devices | 
		
			| Keep settings | Update FW without losing current configuration | 
		
			| FIRMWARE CUSTOMIZATION | 
		
			| Operating system | RutOS (OpenWrt based Linux OS) | 
		
			| Supported languages | Busybox shell, Lua, C, C++ | 
		
			| Development tools | SDK package with build environment provided | 
		
			| INPUT / OUTPUT | 
		
			| Input | 1 x Digital Input, 0 - 6 V detected as logic low, 8 - 30 V detected as logic high | 
		
			| Output | 1 x Digital Output, Open collector output, max output 30 V, 300 mA | 
		
			| Events | Email, RMS, SMS | 
		
			| I/O juggler | Allows to set certain I/O conditions to initiate event | 
		
			| POWER | 
		
			| Connector | 4 pin industrial DC power socket | 
		
			| Input voltage range | 9 – 30 VDC, reverse polarity protection, surge protection >33 VDC 10us max | 
		
			| PoE (passive) | Passive PoE over spare pairs (available from HW revision 0007 and batch number 0010). Possibility to power up through LAN port, not compatible with IEEE802.3af, 802.3at and 802.3bt | 
		
			| Power consumption | < 2 W idle, < 7 W Max | 
		
			| PHYSICAL INTERFACES (PORTS, LEDS, BUTTONS, SIM) | 
		
			| Ethernet | 4 x RJ45 ports, 10/100 Mbps | 
		
			| I/O’s | 1 x Digital Input, 1 x Digital Output on 4 pin power connector | 
		
			| Status LEDs | 1 x bi-color connection status LED, 5 x connection strength LEDs, 4 x LAN status LEDs, 1 x Power LED | 
		
			| SIM | 2 x SIM slots (Mini SIM - 2FF), 1.8 V/3 V, external SIM holders, eSIM (Optional) | 
		
			| Power | 1 x 4 pin DC connector | 
		
			| Antennas | 2 x SMA for LTE, 1 x RP-SMA for WiFi antenna connectors | 
		
			| Reset | Reboot/Factory reset button | 
		
			| PHYSICAL SPECIFICATION | 
		
			| Casing material | Aluminium housing with DIN rail mounting option, plastic panels | 
		
			| Dimensions (W x H x D) | 110 x 50 x 100 mm | 
		
			| Weight | 297 g | 
		
			| Mounting options | DIN rail (can be mounted on two sides), flat surface placement | 
		
			| OPERATING ENVIRONMENT | 
		
			| Operating temperature | -40 °C to 75 °C | 
		
			| Operating humidity | 10% to 90% non-condensing | 
		
			| Ingress Protection Rating | IP30 | 
	
 
Viết đánh giá